Drayton digistat rf1 wireless system manual

Drayton Digistat +RF Room Thermostat Wireless Models:RF QUICK RF COMMISSIONING GUIDE Drayton Digistat + RF Wireless System WARNING If you do not have the knowledge to install the SCR safely then you must arrange for a competent electrician to install it for you. Wiring must conform to the current IEE regulations. View the manual for the Drayton Digistat+RF here, for free. This manual comes under the category Thermostat and has been rated by 1 people with an average of a This manual is available in the following languages: English. Do you have a question about the Drayton Digistat+RF or do you need help? Ask your question here89%(1). MANUAL OVERRIDE The heating can be manually switched on and off by using the ‘OVERRIDE’ button on the SCR in a fault situation, even though the red LED will stay on until a satisfactory signal is reinstated. Once the SCR receives a satisfactory signal again, it will automatically reset itself for normal operation. Digistat RF 1 ‘Wireless System’.

COMMISSIONING THE DRAYTON DIGISTAT RF WIRELESS SYSTEM 1. Pop the Digistat unit off the wall and take over to SCR unit 2. Pull down battery drawers in Digistat unit and allow screen to go blank 3. Turn off the power supply to the SCR receiver unit and leave for 5 seconds 4. Turn on power to SCR unit and check red light is on 5. DIGISTAT RF1 Once the ‘wireless system’ has been commissioned the unit will display the actual room temperature. The SET temperature comes preset at 20°C, if the actual room temperature is below 20°C, a ‘flame’ symbol will appear at the left hand side of the display, this indicates a demand for heat (system will switch on). MANUAL OVERRIDE Digistat RF 1 'Wireless System' User instructions Drayton. DIGISTAT RF1 Once the 'wireless system' has been commissioned the unit will display the actual room temperature. The SET temperature comes preset at 20°C, if the. Manual Drayton Digistat+2RF.

See instructions data sheet Digistat RF. Wireless System Drayton RF Digistat SCR (Single Channel. Receiver) Fault Finding flow chart. Fully working Digistat RF1 Wireless System with SCR receiver boiler thermostat. Instructions:COMMISSIONING THE DRAYTON DIGISTAT RF WIRELESS SYSTEM1. I have a Drayton Digistat Rf1 Wireless System which has jsut stopped close to the boiler as the instructions that came with the new battery drawers say.